All Outputs (56)

Highly-integrated power cell for high-power wide band-gap power converters (2017)
Conference Proceeding
Espina, J., Ahmadi, B., Empringham, L., De Lillo, L., & Johnson, C. M. (2017). Highly-integrated power cell for high-power wide band-gap power converters.

The fast switching speeds and low specific conduction losses of wide band-gap semiconductors allow the realisation of high-frequency, high power-density switching converters with dramatically reduced passive component requirements compared to Silicon... Read More about Highly-integrated power cell for high-power wide band-gap power converters.

Design and construction of a co-planar power bus interconnect for low inductance switching (2017)
Conference Proceeding
Lin, X., Li, J., & Johnson, M. (2017). Design and construction of a co-planar power bus interconnect for low inductance switching. In 2017 IEEE International Workshop On Integrated Power Packaging (IWIPP) (1-4). https://doi.org/10.1109/IWIPP.2017.7936755

A co-planar tab-slot type of interconnect demonstrator for connecting power switching devices and DC bus capacitors has been designed and constructed, aimed at low inductance switching. The demonstrator is composed of a double-sided tab connector and... Read More about Design and construction of a co-planar power bus interconnect for low inductance switching.

A Physical RC Network Model for Electrothermal Analysis of a Multichip SiC Power Module (2017)
Journal Article
Li, J., Castellazzi, A., Eleffendi, M. A., Gurpinar, E., Johnson, C. M., & Mills, L. (2018). A Physical RC Network Model for Electrothermal Analysis of a Multichip SiC Power Module. IEEE Transactions on Power Electronics, 33(3), 2494-2508. https://doi.org/10.1109/TPEL.2017.2697959

© 2017 IEEE. This paper is concerned with the thermal models which can physically reflect the heat-flow paths in a lightweight three-phase half-bridge two-level SiC power module with six MOSFETs and can be used for coupled electrothermal simulation.... Read More about A Physical RC Network Model for Electrothermal Analysis of a Multichip SiC Power Module.

Interconnect materials enabling IGBT modules to achieve stable short circuit failure behavior (2017)
Journal Article
Li, J., Yaqub, I., Corfield, M., & Johnson, C. M. (2017). Interconnect materials enabling IGBT modules to achieve stable short circuit failure behavior. IEEE Transactions on Components, Packaging, and Manufacturing Technology, 7(5), 734-744. https://doi.org/10.1109/TCPMT.2017.2683202

Insulated gate bipolar transistor (IGBT) modules, which can fail to stable short-circuit mode, have major applications in electricity network-related fields. Sn-3.5Ag solder joints and sintered Ag joints for the die attachment and Mo, Cu, Sn-3.5Ag, A... Read More about Interconnect materials enabling IGBT modules to achieve stable short circuit failure behavior.

Suppression of electromagnetic interference using screening and shielding techniques within switching cells (2017)
Conference Proceeding
Zhang, Z., & Johnson, C. M. (2017). Suppression of electromagnetic interference using screening and shielding techniques within switching cells.

in this paper we introduce the use of combination of screening and shielding to suppress electromagnetic interference (EMI) generated by a switching cell. We investigate the screening of common mode (CM) currents and the shielding of magnetic fields... Read More about Suppression of electromagnetic interference using screening and shielding techniques within switching cells.

In-Service Diagnostics for Wire-Bond Lift-off and Solder Fatigue of Power Semiconductor Packages (2017)
Journal Article
Eleffendi, M. A., & Johnson, C. M. (2017). In-Service Diagnostics for Wire-Bond Lift-off and Solder Fatigue of Power Semiconductor Packages. IEEE Transactions on Power Electronics, 32(9), 7187-7198. https://doi.org/10.1109/TPEL.2016.2628705

Wire-bond lift-off and Solder fatigue are degradation mechanisms that dominate the lifetime of power semiconductor packages. Although their lifetime is commonly estimated at the design stage, based on mission profiles and Physics-of-Failure models, t... Read More about In-Service Diagnostics for Wire-Bond Lift-off and Solder Fatigue of Power Semiconductor Packages.

SiC and GaN power transistors switching energy evaluation in hard and soft switching conditions (2016)
Conference Proceeding
Li, K., Evans, P., & Johnson, C. M. (2016). SiC and GaN power transistors switching energy evaluation in hard and soft switching conditions.

SiC and GaN power transistors switching energy are compared in this paper. In order to compare switching energy Esw of the same power rating device, a theoretical analysis is given to compare SiC device conduction loss and switching losses change whe... Read More about SiC and GaN power transistors switching energy evaluation in hard and soft switching conditions.

A novel full soft-switching resonant power converter for mid-feeder voltage regulation of low voltage distribution network (2016)
Conference Proceeding
Ji, C., Watson, A. J., Clare, J. C., & Johnson, C. M. (2016). A novel full soft-switching resonant power converter for mid-feeder voltage regulation of low voltage distribution network. In 2016 18th European Conference on Power Electronics and Applications (EPE'16 ECCE Europe) (1-6). https://doi.org/10.1109/EPE.2016.7695398

This paper presents a novel resonant based, high power density power electronics converter solution for mid-feeder voltage regulation of a low voltage (LV) distribution network. Owing to the use of high switching frequency operation and a full soft-s... Read More about A novel full soft-switching resonant power converter for mid-feeder voltage regulation of low voltage distribution network.

SiC/GaN power semiconductor devices theoretical comparison and experimental evaluation (2016)
Conference Proceeding
Li, K., Evans, P., & Johnson, C. M. (2016). SiC/GaN power semiconductor devices theoretical comparison and experimental evaluation.

SiC and GaN power transistors conduction loss and switching losses are compared in this paper. In order to compare performance of the same power rating device, a theoretical analysis is given to compare SiC device conduction loss and switching losses... Read More about SiC/GaN power semiconductor devices theoretical comparison and experimental evaluation.

Developing power semiconductor device model for virtual prototyping of power electronics systems (2016)
Conference Proceeding
Li, K., Evans, P., & Johnson, C. M. (2016). Developing power semiconductor device model for virtual prototyping of power electronics systems.

Virtual prototyping (VP) is very important for power electronics systems design. A virtual prototyping design tool based on different modelling technology and model order reduction is proposed in the paper. In order to combine circuit electromagnetic... Read More about Developing power semiconductor device model for virtual prototyping of power electronics systems.

GaN-HEMT dynamic ON-state resistance characterisation and modelling (2016)
Conference Proceeding
Li, K., Evans, P., & Johnson, C. M. (2016). GaN-HEMT dynamic ON-state resistance characterisation and modelling.

GaN-HEMTs suffer from trapping effects which might increase device ON-state resistance (RDS(on)) values. Thus, dynamic RDS(on) of a commercial GaN-HEMT is characterized at different bias voltages in the paper by a proposed measurement circuit. Based... Read More about GaN-HEMT dynamic ON-state resistance characterisation and modelling.

Damage Evolution in Al Wire Bonds Subjected to a Junction Temperature Fluctuation of 30K (2016)
Journal Article
Agyakwa, P., Yang, L., Arjmand, E., Evans, P., Corfield, M., & Johnson, C. M. (2016). Damage Evolution in Al Wire Bonds Subjected to a Junction Temperature Fluctuation of 30K. Journal of Electronic Materials, 45, 3659-3672. https://doi.org/10.1007/s11664-016-4519-0

© 2016, The Author(s). Ultrasonically bonded heavy Al wires subjected to a small junction temperature fluctuation under power cycling from 40°C to 70°C were investigated using a non-destructive three-dimensional (3-D) x-ray tomography evaluation appr... Read More about Damage Evolution in Al Wire Bonds Subjected to a Junction Temperature Fluctuation of 30K.

Predicting Lifetime of Thick Al Wire Bonds Using Signals Obtained From Ultrasonic Generator (2016)
Journal Article
Arjmand, E., Agyakwa, P., Corfield, M., Li, J., & Johnson, C. M. (2016). Predicting Lifetime of Thick Al Wire Bonds Using Signals Obtained From Ultrasonic Generator. IEEE Transactions on Components, Packaging, and Manufacturing Technology, 6(5), 814-821. https://doi.org/10.1109/TCPMT.2016.2543001

Routine monitoring of the wire bonding process requires real-time evaluation and control of wire bond quality. In this paper, we present a nondestructive technique for detecting bond quality by the application of a semisupervised classification algor... Read More about Predicting Lifetime of Thick Al Wire Bonds Using Signals Obtained From Ultrasonic Generator.

Integrated motor drives: state of the art and future trends (2016)
Journal Article
Abebe, R., Vakil, G., Lo Calzo, G., Cox, T., Lambert, S., Johnson, C. M., …Mecrow, B. (2016). Integrated motor drives: state of the art and future trends. IET Electric Power Applications, 10(8), 757-771. https://doi.org/10.1049/iet-epa.2015.0506

With increased need for high power density, high efficiency and high temperature capabilities in aerospace and automotive applications, integrated motor drives (IMD) offers a potential solution. However, close physical integration of the converter an... Read More about Integrated motor drives: state of the art and future trends.

Hybrid HVDC circuit breaker with self-powered gate drives (2016)
Journal Article
Effah, F. B., Watson, A. J., Ji, C., Amankwah, E. K., Johnson, C. M., Davidson, C., & Clare, J. C. (2016). Hybrid HVDC circuit breaker with self-powered gate drives. IET Power Electronics, 9(2), 228-236. https://doi.org/10.1049/iet-pel.2015.0531

The ever increasing electric power demand and the advent of renewable energy sources have revived the interest in high-voltage direct current (HVDC) multi-terminal networks. However, the absence of a suitable circuit breaker or fault tolerant VSC st... Read More about Hybrid HVDC circuit breaker with self-powered gate drives.

Low inductance 2.5kV packaging technology for SiC switches (2016)
Conference Proceeding
Mouawad, B., Li, J., Castellazzi, A., Johnson, C. M., Erlbacher, T., & Friedriches, P. (2016). Low inductance 2.5kV packaging technology for SiC switches.

The switching speed of power semiconductors has reached levels where conventional semiconductors packages limit the achievable performance due to relatively high parasitic inductance and capacitance. This paper presents a novel packaging structure wh... Read More about Low inductance 2.5kV packaging technology for SiC switches.

Real-time deterministic power flow control through dispatch of distributed energy resources (2015)
Journal Article
Fazeli, A., Sumner, M., Johnson, C. M., & Christopher, E. (2015). Real-time deterministic power flow control through dispatch of distributed energy resources. IET Generation, Transmission and Distribution, 9(16), https://doi.org/10.1049/iet-gtd.2015.0182

Integration of intermittent renewable resources and mass electrification of heat and transport into the existing electricity network, with limited network asset reinforcement requires incorporation of intelligence in form of active management of flex... Read More about Real-time deterministic power flow control through dispatch of distributed energy resources.

Dependence of overcurrent failure modes of IGBT modules on interconnect technologies (2015)
Journal Article
Yaqub, I., Li, J., & Johnson, C. M. (2015). Dependence of overcurrent failure modes of IGBT modules on interconnect technologies. Microelectronics Reliability, 55(12), 2596-2605. https://doi.org/10.1016/j.microrel.2015.09.020

Insulated gate bipolar transistor (IGBT) modules which can fail to short circuit mode have great of applications in electricity network related fields. Single IGBT samples have been constructed with the standard Al wire bonding, flexible printed circ... Read More about Dependence of overcurrent failure modes of IGBT modules on interconnect technologies.

Application of Kalman Filter to Estimate Junction Temperature in IGBT Power Modules (2015)
Journal Article
Eleffendi, M. A., & Johnson, C. M. (2016). Application of Kalman Filter to Estimate Junction Temperature in IGBT Power Modules. IEEE Transactions on Power Electronics, 31(2), 1576-1587. https://doi.org/10.1109/TPEL.2015.2418711

Knowledge of instantaneous junction temperature is essential for effective health management of power converters, enabling safe operation of the power semiconductors under all operating conditions. Methods based on fixed thermal models are typically... Read More about Application of Kalman Filter to Estimate Junction Temperature in IGBT Power Modules.

A novel stochastic modelling approach for electric vehicle charging power and energy requirements (2015)
Conference Proceeding
Fazeli, A., Johnson, C. M., Sumner, M., & Christopher, E. (2015). A novel stochastic modelling approach for electric vehicle charging power and energy requirements.

Electrification of heat and transport in addition to integration of intermittent renewable resources into the existing electricity network is expected to occur in near future. Such a transformation is expected to force the operation of the electricit... Read More about A novel stochastic modelling approach for electric vehicle charging power and energy requirements.