All Outputs (12)

Dual Antiplatelet Treatment up to 72 Hours after Ischemic Stroke (2023)
Journal Article

BACKGROUND: Dual antiplatelet treatment has been shown to lower the risk of recurrent stroke as compared with aspirin alone when treatment is initiated early (≤24 hours) after an acute mild stroke. The effect of clopidogrel plus aspirin as compared w... Read More about Dual Antiplatelet Treatment up to 72 Hours after Ischemic Stroke.

Hybrid sensible-latent heat thermal energy storage using natural stones to enhance heat transfer: Energy, exergy, and economic analysis (2023)
Journal Article

Latent heat thermal energy storage addresses the mismatch between energy supply and demand; however, phase change materials (PCM) commonly have the issue of low thermal conductivity. Natural stones, as low-cost and environmentally friendly sensible h... Read More about Hybrid sensible-latent heat thermal energy storage using natural stones to enhance heat transfer: Energy, exergy, and economic analysis.

Experimental analysis of mismatch in electro-thermal device parameter within parallel connected SiC MOSFETs: Considerations for multi-chip power module design (2023)
Conference Proceeding

This paper aims to investigate the current imbalance within parallel connected common-source configuration of SiC Power MOSFET switches using double pulse transient operation. Mismatches in electro-thermal parameters e.g., threshold voltage (Vth and... Read More about Experimental analysis of mismatch in electro-thermal device parameter within parallel connected SiC MOSFETs: Considerations for multi-chip power module design.

Realizing ultrahigh ZT value and efficiency of the Bi2Te3 thermoelectric module by periodic heating (2023)
Journal Article

Thermoelectric power generation is regarded as a promising technology to convert waste heat into electricity. This study aims to address the low conversion efficiency of thermoelectric modules and introduces a novel periodic heating method to enhance... Read More about Realizing ultrahigh ZT value and efficiency of the Bi2Te3 thermoelectric module by periodic heating.

A modified Control Strategy of Neutral-Point Clamped Converter-Fed PMSM Drives with Engergy Storage Systems (2023)
Conference Proceeding

This paper proposes a modified control strategy for three-phase three-level neutral point clamped (NPC) converter-fed Permanent Magnet Synchronous Motor (PMSM) drive in the application of Energy Storage Systems (ESS) using single-carrier modulation.... Read More about A modified Control Strategy of Neutral-Point Clamped Converter-Fed PMSM Drives with Engergy Storage Systems.

Exhaust channel optimization of the automobile thermoelectric generator to produce the highest net power (2023)
Journal Article

The automobile thermoelectric generator is a promising energy conversion technology to enhance fuel economy and decrease the fuel consumption of vehicles. In order to boost the performance of the automobile thermoelectric generator, the fin distance... Read More about Exhaust channel optimization of the automobile thermoelectric generator to produce the highest net power.

Dynamic behaviour of automobile thermoelectric waste heat recovery under different driving cycles (2023)
Journal Article

Different types of vehicles often run in different driving cycles, resulting in different dynamic behaviours of the automobile thermoelectric generator. The dynamic performance of a simplified automobile thermoelectric generator under different drivi... Read More about Dynamic behaviour of automobile thermoelectric waste heat recovery under different driving cycles.

Recent development in structural designs and thermal enhancement technologies of thermoelectric generator with different types of heat sources: A review (2023)
Journal Article

Study on high-speed electric motor cooling with oil spray (2023)
Journal Article

A Class-E-Based Multichannel Auxiliary Power Supply with Individual Hysteresis Control (2023)
Journal Article

A high performance auxiliary power supply (APS) with multiple isolated outputs plays a crucial role in ensuring the effective operation of power converter systems. An isolated resonant current source converter is usually adopted as the APS in medium-... Read More about A Class-E-Based Multichannel Auxiliary Power Supply with Individual Hysteresis Control.

Optimal design of a heat exchanger for automotive thermoelectric generator systems applied to a passenger car (2023)
Journal Article

The heat exchanger determines the overall performance of automotive thermoelectric generator (ATEG) systems. To obtain the accurate performance of the ATEG system under actual driving conditions, a fluid-thermal-electric multiphysics numerical model... Read More about Optimal design of a heat exchanger for automotive thermoelectric generator systems applied to a passenger car.

Thermal and electrical contact resistances of thermoelectric generator: Experimental study and artificial neural network modelling (2023)
Journal Article

Thermal and electrical contact resistances (TCR and ECR) of thermoelectric generator (TEG) exert essential impacts on its performance. In this study, through a series of experiments these two important properties have been estimated in a wide range o... Read More about Thermal and electrical contact resistances of thermoelectric generator: Experimental study and artificial neural network modelling.