All Outputs (4)

On the Microstructural Evolution and Failure Mechanism in Laser Powder Bed Fusioned Ti-6Al-4V during Low Cycle Fatigue at Room and Elevated Temperatures (2022)
Journal Article
Gupta, A., Bennett, C. J., Sun, W., & Neate, N. (2022). On the Microstructural Evolution and Failure Mechanism in Laser Powder Bed Fusioned Ti-6Al-4V during Low Cycle Fatigue at Room and Elevated Temperatures. Journal of Materials Research and Technology, 21, 4299-4319. https://doi.org/10.1016/j.jmrt.2022.10.141

Microstructural features and their evolution during cyclic deformation directly impact the low cycle fatigue (LCF) life of additively manufactured Laser Powder Bed Fusion (LPBF) Ti-6Al-4V. Tensile and strain controlled LCF tests were performed at roo... Read More about On the Microstructural Evolution and Failure Mechanism in Laser Powder Bed Fusioned Ti-6Al-4V during Low Cycle Fatigue at Room and Elevated Temperatures.

An inverse analysis method for determining abradable constitutive properties (2022)
Journal Article
Lye, R., Bennett, C., Rouse, J., & Zumpano, G. (2022). An inverse analysis method for determining abradable constitutive properties. Materials Today Communications, 33, Article 104571. https://doi.org/10.1016/j.mtcomm.2022.104571

Abradable coatings enable small tip clearances within gas turbine engines to be achieved. These coatings allow blades to cut their ideal paths during engine running-in and act as a sacrificial layer during unforeseen blade-casing interactions, minimi... Read More about An inverse analysis method for determining abradable constitutive properties.

CFD Approach to the Influence of Particle Size on Erosive Wear in Coal Riser Pipes (2022)
Journal Article
Ogunlela, P. T., Giddings, D., Bennett, C., Born, S., Klaassen, M., Gennissen, I., & Farnish, R. (2022). CFD Approach to the Influence of Particle Size on Erosive Wear in Coal Riser Pipes. Journal of Fluid Flow, Heat and Mass Transfer, 9, 43-48. https://doi.org/10.11159/jffhmt.2022.006

Pneumatic conveying of finely pulverised coal particles is an important process in the steelmaking industry, used to transport coal to the blast furnace. Erosive wear caused by high velocity particles impacting on the inner wall surfaces of pneumatic... Read More about CFD Approach to the Influence of Particle Size on Erosive Wear in Coal Riser Pipes.

Numerical and Experimental Analysis of the Deformation Behavior of CoCrFeNiMn High Entropy Alloy Particles onto Various Substrates During Cold Spraying (2022)
Journal Article
Akisin, C. J., Bennett, C. J., Venturi, F., Assadi, H., & Hussain, T. (2022). Numerical and Experimental Analysis of the Deformation Behavior of CoCrFeNiMn High Entropy Alloy Particles onto Various Substrates During Cold Spraying. Journal of Thermal Spray Technology, 31(4), 1085-1111. https://doi.org/10.1007/s11666-022-01377-1

The bonding mechanisms of a wide range of metallic materials in cold spraying have been studied, mainly attributed to adiabatic shear instability (ASI) at high strain rates, whereas the impact and deformation behavior of high entropy alloys (HEAs) on... Read More about Numerical and Experimental Analysis of the Deformation Behavior of CoCrFeNiMn High Entropy Alloy Particles onto Various Substrates During Cold Spraying.