Centrifuge modeling of the impact of local and global scour erosion on the monotonic lateral response of a monopile in sand
Li, Qiang; Prendergast, L. J.; Askarinejad, A.; Chortis, G.; Gavin, K.
LUKE PRENDERGAST LUKE.PRENDERGAST@NOTTINGHAM.AC.UK
Copyright © 2020 by ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. The majority of offshore wind turbines are founded on large-diameter, open-ended steel monopiles. Monopiles must resist lateral loads and overturning moments because of environmental (wind and wave) actions, whereas vertical loads tend to be comparatively small. Recent developments in turbine sizes and increases in hub heights have resulted in pile diameters increasing rapidly, whereas the embedment length to diameter ratio (L/D) is reducing. Soil erosion around piles, termed scour, changes the soil strength and stiffness properties and affects the system's load resistance characteristics. In practice, design scour depths of up to 1.3D are routinely assumed during the turbine lifetime; however, the impact on monopiles with low L/D is not yet fully understood. In this article, centrifuge tests are performed to assess the effect of scour on the performance of piles with low L/D. In particular, the effect of combined loads, scour type (global, local), and depth are considered. A loading system is developed that enables application of realistic load eccentricity and combined vertical, horizontal, and moment loading at the seabed level. An instrumented 1.8-m-diameter pile with L/D = 5 is used. A friction-reducing ball-type connection is designed to transfer lateral loads to the pile without inducing any rotational pile-head constraint, which is associated with loading rigs in tests of this nature. Results suggest that vertical and lateral load interaction is minimal. Scour has a significant impact on the lateral load-bearing capacity and stiffness of the pile, leads to increases in bending moment magnitude along the pile shaft, and lowers the location of peak pile bending moment. The response varies with scour type, with global scour resulting in larger moments than local scour. The size of the local scour hole is found to have a significant impact on the pile response, suggesting that scour hole width should be explicitly considered in design.
Li, Q., Li, Q., Prendergast, L. J., Askarinejad, A., Chortis, G., & Gavin, K. (2020). Centrifuge modeling of the impact of local and global scour erosion on the monotonic lateral response of a monopile in sand. Geotechnical Testing Journal, 43(5), 20180322. https://doi.org/10.1520/GTJ20180322
|Journal Article Type||Article|
|Acceptance Date||Oct 23, 2019|
|Online Publication Date||Jan 10, 2020|
|Publication Date||Jan 10, 2020|
|Deposit Date||Nov 28, 2019|
|Publicly Available Date||Jan 11, 2021|
|Journal||Geotechnical Testing Journal|
|Peer Reviewed||Peer Reviewed|
|Keywords||Geotechnical Engineering and Engineering Geology|
You might also like
Effect of scour erosion on mode shapes of a 5 MW monopile-supported offshore wind turbine