Muhammad Rabiu Ado
Dynamic simulation of the THAI heavy oil recovery process
Rabiu Ado, Muhammad; Greaves, Malcolm; Rigby, Sean P.
Sean P. Rigby
Toe-to-Heel Air Injection (THAI) is a variant of conventional In-Situ Combustion (ISC) that uses a horizontal production well to recover mobilised partially upgraded heavy oil. It has a number of advantages over other heavy oil recovery techniques such as high recovery potential. However, existing models are unable to predict the effect of the most important operational parameters, such as fuel availability and produced oxygen concentration, which will give rise to unsafe designs. Therefore, we have developed a new model that accurately predicts dynamic conditions in the reservoir and also is easily scalable to investigate different field scenarios. The model used a three component direct conversion cracking kinetics scheme, which does not depend on the stoichiometry of the products and, thus, reduces the extent of uncertainty in the simulation results as the number of unknowns is reduced. The oil production rate and cumulative oil produced were well predicted, with the latter deviating from the experimental value by only 4%. The improved ability of the model to emulate real process dynamics meant it also accurately predicted when the oxygen was first produced, thereby enabling a more accurate assessment to be made of when it would be safe to shut-in the process, prior to oxygen breakthrough occurring. The increasing trend in produced oxygen concentration following a step change in the injected oxygen rate by 33 % was closely replicated by the model. The new simulations have now elucidated the mechanism of oxygen production during the later stages of the experiment. The model has allowed limits to be placed on the air injection rates that ensure stability of operation. Unlike previous models, the new simulations have provided better quantitative prediction of fuel laydown, which is a key phenomenon that determines whether, or not, successful operation of the THAI process can be achieved. The new model has also shown that, for completely stable operation, the combustion zone must be restricted to the upper portion of the sand pack, which can be achieved by using higher producer back pressure.
|Journal Article Type||Article|
|Publication Date||Feb 16, 2017|
|Journal||Energy and Fuels|
|Publisher||American Chemical Society|
|Peer Reviewed||Peer Reviewed|
|APA6 Citation||Rabiu Ado, M., Greaves, M., & Rigby, S. P. (2017). Dynamic simulation of the THAI heavy oil recovery process. Energy and Fuels, 31(2), 1276-1284. https://doi.org/10.1021/acs.energyfuels.6b02559|
|Keywords||Bitumen; in-situ-combustion; oil recovery; simulation; kinetics|
|Copyright Statement||Copyright information regarding this work can be found at the following address: http://eprints.nottingh.../end_user_agreement.pdf|
|Additional Information||This document is the Accepted Manuscript version of a Published Work that appeared in final form in Energy and Fuels, copyright © American Chemical Society
after peer review and technical editing by the publisher.
To access the final edited and published work see [insert ACS Articles on Request author-directed link to Published Work, see http://pubs.acs.org/doi...acs.energyfuels.6b02559
Copyright information regarding this work can be found at the following address: http://eprints.nottingham.ac.uk/end_user_agreement.pdf
You might also like
Pore structural evolution of shale following thermochemical treatment
New perspectives on supercritical methane adsorption in shales and associated thermodynamics
Microwave synthesis of carbon onions in fractal aggregates using heavy oil as a precursor
Impact of oil composition on microwave heating behavior of heavy oils