An imidazolium-based supramolecular gelator enhancing interlayer adhesion in 3D printed dual network hydrogels

Zhou, Zuoxin; Samperi, Mario; Santu, Lea; Dizon, Glenieliz; Aboarkaba, Shereen; Limón, David; Tuck, Christopher; Pérez-García, Lluïsa; Irvine, Derek J.; Amabilino, David B.; Wildman, Ricky

Abstract

The variety of UV-curable monomers for 3D printing is limited by a requirement for rapid curing after each sweep depositing a layer. This study proposes to trigger supramolecular self-assembly during the process by a gemini imidazolium-based low-molecular-weight gelator, allowing printing of certain monomers. The as-printed hydrogel structures were supported by a gelator network immobilising monomer:water solutions. A thixotropic hydrogel was formed with a recovery time of <50 s, storage modulus = 8.1 kPa and yield stress = 18 Pa, processable using material extrusion 3D printing. Material extrusion 3D printed objects are usually highly anisotropic, but in this case the gelator network improved the isotropy by subverting the usual layer-by-layer curing strategy. The monomer in all printed layers was cured simultaneously during post-processing to form a continuous polymeric network. The two networks then physically interpenetrate to enhance mechanical performance. The double network hydrogels fabricated with layers cured simultaneously showed 62–147% increases in tensile properties compared to layer-by-layer cured hydrogels. The results demonstrated excellent inter- and intra-layered coalescence. Consequently, the tensile properties of 3D printed hydrogels were close to mould cast objects. This study has demonstrated the benefits of using gelators to expand the variety of 3D printable monomers and shown improved isotropy to offer excellent mechanical performances.

Citation

Zhou, Z., Samperi, M., Santu, L., Dizon, G., Aboarkaba, S., Limón, D., …Wildman, R. (2021). An imidazolium-based supramolecular gelator enhancing interlayer adhesion in 3D printed dual network hydrogels. Materials and Design, 206, Article 109792. https://doi.org/10.1016/j.matdes.2021.109792

• Journal Article Type: Article
• Acceptance Date: May 2, 2021
• Online Publication Date: May 5, 2021
• Publication Date: Aug 1, 2021
• Deposit Date: May 24, 2021
• Publicly Available Date: May 24, 2021
• Journal: Materials and Design
• Print ISSN: 0264-1275
• Electronic ISSN: 1873-4197
• Publisher: Elsevier
• Peer Reviewed: Peer Reviewed
• Volume: 206
• Article Number: 109792
• DOI: https://doi.org/10.1016/j.matdes.2021.109792
• Keywords: Mechanical Engineering; General Materials Science; Mechanics of Materials
• Public URL: https://nottingham-repository.worktribe.com/output/5569761
• Publisher URL: https://www.sciencedirect.com/science/article/pii/S0264127521003452?via%3Dihub