All Outputs (46)

Corrosion behaviour of crystalline and amorphous forms of the glass forming alloy Fe43Cr16Mo16C15B10 (2012)
Journal Article
Bakare, M., Voisey, K., Chokethawai, K., & McCartney, D. (in press). Corrosion behaviour of crystalline and amorphous forms of the glass forming alloy Fe43Cr16Mo16C15B10. Journal of Alloys and Compounds, 527, https://doi.org/10.1016/j.jallcom.2012.02.127

The corrosion behaviour of both crystalline and largely amorphous forms of the Fe-based glass forming alloy, Fe43Cr16Mo16C15B10 alloy was investigated. Two different methods were used to induce transformation to the amorphous form of the alloy: laser... Read More about Corrosion behaviour of crystalline and amorphous forms of the glass forming alloy Fe43Cr16Mo16C15B10.

Factors affecting pre-failure instability of sand under plane-strain conditions (2012)
Journal Article
Wanatowski, D., & Chu, J. (2012). Factors affecting pre-failure instability of sand under plane-strain conditions. Géotechnique, 62(2), https://doi.org/10.1680/geot.9.P.111

Experimental data obtained from a plane-strain appara- tus are presented in this paper to show that a pre-failure instability in the form of a rapid and sustained increase in strain rate can occur for both contractive and dilative sand under fully dr... Read More about Factors affecting pre-failure instability of sand under plane-strain conditions.

The interaction of a vortex ring with a sloped sediment layer: critical criteria for incipient grain motion (2012)
Journal Article
Munro, R. J. (in press). The interaction of a vortex ring with a sloped sediment layer: critical criteria for incipient grain motion. Physics of Fluids, 24(2), https://doi.org/10.1063/1.3683555

Experiments were performed to analyse the interaction between a vortex ring and a sloped sediment layer. Attention focussed on interactions under “critical” conditions, in which sediment motion was only just induced by the ring's flow field. Both hyd... Read More about The interaction of a vortex ring with a sloped sediment layer: critical criteria for incipient grain motion.

Research of Detection and Control System for Lunar Dust Effects Simulator (2012)
Journal Article
Liao, Z. R., Zhou, L., Gao, D., Zhang, X. L., & Yin, M. L. (2012). Research of Detection and Control System for Lunar Dust Effects Simulator. Advanced Materials Research, 426, 126-130. https://doi.org/10.4028/www.scientific.net/AMR.426.126

To simluate the effects of lunar dust environment veritably by using lunar dust effects simulator, a detection and control system based on singlechip microcomputer was developed. In this system, peripheral circuits with stepper motor driver, temperat... Read More about Research of Detection and Control System for Lunar Dust Effects Simulator.

Simple Near Exact Image Solution for Vertical Antenna Above Lossy Ground Using Stationary Phase Approximation (2012)
Presentation / Conference Contribution
Tahanian, E., Dadashzadeh, G., & Taghvaee, H. Simple Near Exact Image Solution for Vertical Antenna Above Lossy Ground Using Stationary Phase Approximation. Presented at IEEE NEMO 2012 (Numerical Electromagnetic Modeling and Optimization)

In this paper, the traditional problem of field computation for a vertical radiating antenna above a lossy infinite ground is discussed and revisited. To simplify and solve the traditional solutions consist of complicated integrals of sommerfeld type... Read More about Simple Near Exact Image Solution for Vertical Antenna Above Lossy Ground Using Stationary Phase Approximation.

Modeling the re-anchoring of a ruptured tendon in bonded post-tensioned concrete (2012)
Presentation / Conference Contribution
Abdelatif, A. O., Owen, J. S., & Hussein, M. F. Modeling the re-anchoring of a ruptured tendon in bonded post-tensioned concrete. Presented at Bond in Concrete 2012 – General Aspects of Bond

: In this study, a theoretical model is deve loped to simulate the re-anchorage of a ruptured
bonded post-tensioning tendon. This includes estimating the re-anchorage length and stress distribution over
the tendon. The model accounts for equilibr... Read More about Modeling the re-anchoring of a ruptured tendon in bonded post-tensioned concrete.