All Outputs (5)

Comparison of two noise reduction methods in coherence scanning interferometry for surface measurement (2019)
Conference Proceeding
Gomez, C., Su, R., Lawes, S., & Leach, R. (2019). Comparison of two noise reduction methods in coherence scanning interferometry for surface measurement

Coherence scanning interferometry (CSI) can measure relatively flat surfaces with sub-nanometre precision, but the measurement noise may increase significantly if the intensity of the interferometric signal reduces when measuring non-flat surfaces or... Read More about Comparison of two noise reduction methods in coherence scanning interferometry for surface measurement.

Increasing throughput in x-ray computed tomography measurement of surface topography using sinogram interpolation (2019)
Journal Article
Körner, L., Lawes, S., Bate, D., Newton, L., Senin, N., & Leach, R. K. (2019). Increasing throughput in x-ray computed tomography measurement of surface topography using sinogram interpolation. Measurement Science and Technology, 30(12), Article 125002. https://doi.org/10.1088/1361-6501/ab37e5

© 2019 Crown copyright. Reproduced with the permission of the Controller of Her Majesty's Stationery Office. X-ray computed tomography (XCT) is a non-destructive imaging technique that has recently gained interest as a tool to measure surface topogra... Read More about Increasing throughput in x-ray computed tomography measurement of surface topography using sinogram interpolation.

Characterisation Of The Surface Topography Evolution Of An Ink-jet Printed Transparent Fluoroplastic With CSI (2019)
Presentation / Conference
Gomez, C., Campanelli, C., Su, R., Lawes, S., & Leach, R. (2019, July). Characterisation Of The Surface Topography Evolution Of An Ink-jet Printed Transparent Fluoroplastic With CSI. Poster presented at 22nd International Conference on Metrology & Properties of Surfaces, Lyon, France

We present the results of an empirical investigation into the evolution of the morphology of an ink jet printed trans parent polymer using coherence scanning interferometry (CSI). CSI is a high precision optical surface measuring technique, which ha... Read More about Characterisation Of The Surface Topography Evolution Of An Ink-jet Printed Transparent Fluoroplastic With CSI.

Mathematical reference standards for validating software for calculating surface texture parameters (2019)
Presentation / Conference
Todhunter, L., Leach, R., Lawes, S., Blateyron, F., & Harris, P. (2019, July). Mathematical reference standards for validating software for calculating surface texture parameters. Presented at 22nd International Conference on Metrology and Properties of Surfaces, Lyon, France

Mathematical approach to the validation of functional surface texture parameter software (2019)
Journal Article
Todhunter, L., Leach, R., Lawes, S., Harris, P., & Blateyron, F. (2019). Mathematical approach to the validation of functional surface texture parameter software. Surface Topography: Metrology and Properties, 7(1), Article 015020. https://doi.org/10.1088/2051-672X/ab07ca

A new method for performance validation of surface texture parameter calculation software is introduced, focussing on functional surface texture parameters. Material ratio curves are defined algebraically and used to calculate functional surface text... Read More about Mathematical approach to the validation of functional surface texture parameter software.